Install software (System, MBusHub, QuickPost, Modbus2MBus & Wireless M-Bus)

The following list will explain how to install software in the PiiGAB M-Bus 900 V2 and PiiGAB M-Bus 900S. These steps are either used to install a new software or update an existing.

  1. Download the software as a ZIP-file:
    • Softwares for PiiGAB M-Bus 900S.
  2. Unzip the file to gain access to the tgz-file.
  3. Place the tgz-file somewhere on the computer. Don’t open the tgz-file.
  4. Start the web interface for the gateway in any browser.
  5. Go to the Administration page.
  6. Find the section Update Software.
  7. Press the Browse… button.
  8. Browse to and select the tgz-file.
  9. Press the button Install.
  10. Wait until the installation has finished.

Note: If QuickPost, Modbus2MBus or Wireless M-Bus is not shown in the web browser, please press CTRL + F5.

Categories: Quickpost, 900S/T
Did you find this FAQ helpful?
0
0
0 replies

Comment on this FAQ

Want to join the discussion?
Feel free to contribute!

Comment on this FAQ

Your email address will not be published.