Example of initial contact (PiiGAB M-Bus 810)

Here is an example of how to setup the initial contact with a PiiGAB M-Bus 810.

1. Connect the PiiGAB M-Bus 810 to a network switch.
2. Connect the computer to the same network switch.
3. Configure the computer’s network card with this IP-configuration:
   • IP-address: 192.168.10.1
   • Netmask: 255.255.255.0
   • Gateway: 192.168.10.254
4. Check the IP-configuration with the ipconfig command in the command interpreter.
5. Read the MAC-address of the PiiGAB M-Bus 810 on the right side.
   (Starts with 00-80-A3 or 00-20-A4).
6. Start PiiGAB M-Bus Wizard.
7. In the main menu, select Change gateway IP-settings and press Next.
8. Select Select Setup IP using network (UDP broadcast)..
9. Specify the MAC-address and press Next.
10. Select Use the following IP-address.
11. Specify the following IP-configuration:
    • IP-address: 192.168.10.2
    • Netmask: 255.255.255.0
    • Gateway: 192.168.10.1
12. Press the Next and then Apply..
13. Go ahead to Find gateways on your network. in PiiGAB M-Bus Wizard.

Now you should see the PiiGAB M-Bus Setup display the PiiGAB M-Bus 810 in the list. Check the MAC-address and that the IP-address should be set to 192.168.10.2.