Example of initial contact (PiiGAB M-Bus 900)

Here is an example of how to setup the initial contact with a PiiGAB M-Bus 900.

1. Connect the PiiGAB M-Bus 900 to a network switch.
2. Connect the computer to the same network switch.
3. Configure the computer’s network card with this IP-configuration:
   • IP-address: 192.168.10.1
   • Netmask: 255.255.255.0
   • Gateway: 192.168.10.254
4. Check the IP-configuration with the ipconfig command in the command interpreter.
5. Read the MAC-address of the PiiGAB M-Bus 900 on the right side. (Starts with E8-99-5A).
6. Start PiiGAB M-Bus Wizard.
7. In the main menu, select Change gateway IP-settings and press Next.
8. Select Select Setup IP using network (UDP broadcast)..
9. Specify the MAC-address and press Next.
10. Select Use the following IP-address.
11. Specify the following IP-configuration:
    • IP-address: 192.168.10.2
    • Netmask: 255.255.255.0
    • Gateway: 192.168.10.1
12. Press the Next and then Apply..
    Note: Ignore the error messages displayed in PiiGAB M-Bus Setup Wizard.
13. Wait one minute for the PiiGAB M-Bus 900 to restart.
14. Go ahead to Find gateways on your network. in PiiGAB M-Bus Wizard.

Now you should see the PiiGAB M-Bus Setup display show the PiiGAB M-Bus 900 in the list. Check the MAC-address and the IP-address should be 192.168.10.2.