How to set the timeout

There are three timeouts in the PiiGAB M-Bus Wizard for the three protocols M-Bus, Modbus and MBusASCII. Set each timeout according to how long it takes to get a response to each query that the PiiGAB M-Bus Wizard sends.

Note: For older versions of PiiGAB M-Bus Wizard (3.1.0. or earlier) there was the same timeout for the three different protocols.

To set the respective timeout do the following:

1. In the main menu, select Test, search and configure meters and press Next:
2. Press the Next again.
3. Press the Debug-buttons.
4. Go to the Tools-menu and select Time delays.
5. Enter the desired value for each protocol:
   • M-Bus timeout: For all M-Bus communication.
   • Modbus timeout: To Modbus communication.
   • M-Bus ASCII timeout: For all MBusASCII timeout.
   • Note: In the previous versions, the timeout is called BusTimeout.
6. Press the OK.